ryxlyx
- Total activity 447
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 157
Activity overview
Latest activity by ryxlyx-
ryxlyx commented,
Just a few suggestions, as your "Big Chicken" comment suggests some trepidation. I've cleared many blades like this over the years. Understand that you are making a commitment to sand the blade f...
-
ryxlyx commented,
harder tougher stronger than WHAT steel? K390? M390? Or just the stainless liners BM builds their frames with? Lotsa different steels.Nickel adds toughness to AUS-6 and AUS-8, but it's not pres...
-
ryxlyx commented,
[@mention:589599268366227375] posted: /|\ Just finished some fine tuning on the 945 I’ve been EDCing ( along with my regular 940-1 & 940bk-2004). So that is the latest, yadayadayada. PS If I had...
-
ryxlyx commented,
It's an 800. 804 did have the oval, also didn't have the bold "USA" etched under the b'fly.Check the other side of the blade, should say either M2/HSS or ATS-34. M2 is the better steel.You posted...
-
ryxlyx commented,
I don't comment much anymore, but I will here:I've got 9 folders in my carry drawer, and they're all Benchmades. Nothing to do w/ the fact that I live in PDX, or that they're Made in America. Bou...
-
ryxlyx commented,
yuck
-
ryxlyx commented,
I have several 525m4s. They all have the same thumb studs that my 520s do, that should help-- R.
-
ryxlyx commented,
Ditto on teflon tape, I split it in half as it's wider than needed for this purpose. 10/12 wraps or so, it'll never loosen.
-
ryxlyx commented,
I understand the frustration. Eliminate the abrupt corner, you eliminate much of the problem:Even if all you do is sand/soften the corner, holding the blade 90 degrees to the sandpaper, string/twi...
-
ryxlyx created a post,
WTB: barrage tanto S90V only
got a project in mind. long shot as this is a custom shop knife, but maybe somebody bought a tanto, wish now they'd bought a droppoint. here's your chance to bail-- R.