pixmin
- Total activity 37
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 2
Activity overview
Latest activity by pixmin-
pixmin commented,
I see, that would be why I couldn't find what it was, it's a "burr", thanks a lot for the explanation, much appreciated!
-
pixmin commented,
Thanks for the video(s) very useful.One thing though that keeps coming back and I can't find a good explanation, what really is a "blur" when you sharpen a knife? Is it when the edge is making a "c...
-
pixmin commented,
Thanks ryxlyx, just what I wanted to hear
-
pixmin commented,
The Gransfors round stone has a coarse side and a fine side, that's all it says, it's made of sandstone quarried on the island of Gotland, sweeden, and it's about 6/7cm in diameter.I don't have the...
-
pixmin created a post,
Sharpening a Benchmade 551 Griptilian
Hi,I have been using my 551 for a while and feel it's time to get it sharp again. I have two tools to do this, a round stone (double face, the one from Gransfors that I use to sharpen my axe), and ...
-
pixmin commented,
quote: Originally posted by fastjan:Pixmin, here's a link to it: http://benchmadeforum.com/eve/...573/m/902104444/p/95 Thanks a lot fastjan, I was searching for it on the EDC forum.This is exact...
-
pixmin commented,
quote: Originally posted by loonybin: quote: Originally posted by pixmin:Reasons why I discarded the:950 - A tad to aggressive (so I prefer the 551/550HG and 520, but it comes right after them)810...
-
pixmin commented,
quote: Originally posted by fastjan:Pixmin, I'll post a pic of my re-ground ZT 350 over in the EDC forum for Benchmades and Others. I'd post it here, but forum rules don't allow pictures of non-B...
-
pixmin commented,
quote: Originally posted by TheBlueram234:He Dude,Welcome to the forum. Just read this thread.. and I may repeat or possibly forget why you discarded a knife or two. but here's my .02the Grips hav...
-
pixmin commented,
quote: Originally posted by kestrel57:Reduce the angle of the blade and the ZT0350 will cut very well. It is extremely strong and will not fail (the liner lock). If you want a very strong knife...