How to Center the Blade

geocyclist

• August 14, 2013 22:44

How do you adjust blade centering? How does BM do it? I looked from an old post from Dr. Forthington Pringles but don't see it anymore.

0

• 

  keyman

  • August 14, 2013 23:09

  With the knife closed.
  I would losen all the screws including the clip screws
  Now snug down on the pivot. Not real tight, just hand tight.
  I then gently, but firmly, apply pressure to each side of the knife in opposite directions.
  Left side up/right side down or Left side down/right side up; while at the same time seeing what combination gives you the desired results.
  While holding the right effect, start tightening screws. If the tightening of one particular screw ruins the effect. Tighten this problem screw last.
  Once all screws are tight, adjust pivot.

  0
• 

  geocyclist

  • August 19, 2013 15:03

  Thanks Keyman. I can get movement this way. But not always enough.

  0

Please sign in to leave a comment.